The focus of the debugging of the rubber belt vacuum filter is to make each part continuous and stable, the deviation of the tape and filter cloth can be effectively controlled, and the vacuum system is well sealed and leak-free.

The start procedure of the rubber belt vacuum filter is: open the sealing water valve → start the filter → open the filter cloth flushing valve → start the vacuum valve → open the feed valve and the washing valve, and the filter runs normally.

The stop procedure of the rubber belt vacuum filter is opposite to the start procedure. Only after the feed valve is closed, the filter should be operated continuously for about 2 minutes, and the vacuum valve should be closed. After the filter is stopped for about 15 minutes, the filter cloth It has been cleaned.